FLIR E5 Pro
Detects moisture intrusion, missing insulation, electrical hot-spots and air leaks invisible to the naked eye. We use it on every Frame, Enclosed and PCI inspection to find defects before they become $20k repair bills.
Topcon TP-L6
Verifies wall plumb, ceiling level, tile lippage and door-frame alignment to commercial-build tolerance. The same tool used by site supervisors on $20M projects — not a spirit level on a stick.
NivComp NC 21
Measures slab fall, wet-area grading, balcony drainage and floor flatness to AS 3740 wet-area compliance. Six-point survey across each room — no guesswork, no "looks about right".
Bosch GLM 50-27
Cross-checks every room dimension against the build contract and approved plans. If the master bedroom is 90mm short of the contract drawing, we'll catch it — and you'll get the variation in writing.
Powertech ST3526
Lights up roof voids, subfloors, eave cavities and wall cavities like daylight. 4000 lumens of zoomable beam — enough to spot a snapped truss connection from the manhole without crawling in.
Industry Standards
All our inspections are conducted in accordance with Australian Standards and industry best practices:
- AS 4349.1-2007 (Building Inspections)
- AS 3740 (Wet-area waterproofing)
- AS 3760-2010 (Electrical Safety)
- National Construction Code (NCC)
- Queensland Development Code (QDC)
Inspection Process
Pre-Inspection Planning
Review build contract, plans and previous-stage report; load tools for the stage.
Systematic Inspection
Roof to slab, every room, using the right tool for each defect category.
Digital Documentation
Real-time photo capture with annotations, thermal overlays and laser readings.
Report Delivery
Same-day report with photos and severity grading, issued on-site before we leave most inspections (some exclusions apply for complex builds requiring extended desktop review).